Rear Disc Brake Caliper Assembly Pair

Complete Braking Restoration for Dodge Ram 1500, Durango, and Chrysler Aspen

Restore the hydraulic integrity and stopping power of your vehicle’s rear axle with this premium 2-Piece Rear Brake Caliper Set. Specifically designed for the heavy-duty demands of Chrysler and Dodge trucks and SUVs, these calipers are critical for maintaining balanced braking force and preventing rear-end sway during hard stops. Over time, internal piston seals can degrade and external guide pins can seize due to road salt and moisture, leading to "dragging" brakes, overheating, and premature pad wear.

Each unit is precision-manufactured to match factory performance, featuring high-grade seals and a corrosion-resistant finish. This set comes fully assembled with the mounting brackets and necessary hardware, providing a direct-fit, "bolt-on" solution that eliminates the hassle of cleaning and reusing old, pitted components.

Fitment Verification and Vehicle Applications

This set is designed for the Rear Driver (Left) and Rear Passenger (Right) positions. Please verify your wheel lug count and trim level:

• Ram 1500 / Dodge Ram 1500: 2002–2018 (Fits 5-Lug wheel configurations specifically for 2006, 2007, 2008, 2012–2015 models).

• Dodge Durango: 2004, 2005, 2006, 2007, 2008, 2009.

• Chrysler Aspen: 2007, 2008, 2009.

• Dodge Ram Van (1500, 2500, 3500): 2003.

• Fitment Note: Ensure your vehicle is equipped with rear disc brakes and uses the 5-lug hub pattern where specified.

Technical Specifications and Attributes

• Quantity: 2-Piece Set (Covers both Rear Driver and Passenger sides).

• Piston Material: Heavy-Duty Steel.

• Casting Material: High-Strength Iron.

• Brake System: Disc.

• Hardware Included: Yes (Stainless steel clips and guide pin boots).

• Brackets Included: Yes (Fully assembled).

• Fitment Type: Direct Replacement.

What’s in the Box

• (1) Rear Driver Side (LH) Brake Caliper

• (1) Rear Passenger Side (RH) Brake Caliper

• (2) Caliper Mounting Brackets

• (1) Installation Hardware Kit

Industry Cross-Reference Numbers

• CARDONE Reman: 18-B4836, 18-B4837

• Raybestos Brakes: FRC11307, FRC11308, FRC11625, FRC11626

• ACDelco: 18FR1934, 18FR1935

• BBB Industries: 99-17697L-C, 99-17697R-C

• UCX: 14-1088, 14-1089

Installation and Technical Tips

• Replace Crush Washers: Always use new copper crush washers on the brake line banjo bolt to prevent fluid leaks. Small, slow leaks at the banjo bolt are the primary cause of a "spongy" brake pedal after installation.

• Bleed the System: A full system bleed is required to remove air from the lines. Always start with the wheel furthest from the master cylinder (Passenger Rear) and work your way forward to the Driver Front.

• Grease the Slides: Ensure the caliper slide pins are properly lubricated with high-temperature silicone brake grease. This allows the caliper to "float" freely, preventing the inner pad from wearing down faster than the outer pad.

• Parking Brake Check: On these models, the parking brake is often a "drum-in-hat" system located inside the rear rotor. While the calipers are off, inspect the parking brake shoes for wear and adjust them if necessary to ensure your emergency brake holds firmly on inclines.