Front Passenger Side Exterior Door Handle

Paint-to-Match Outside Handle for 2011–2014 Hyundai Sonata

Restore the clean lines and dependable function of your sedan with this Premium Front Right (Passenger Side) Exterior Door Handle. Specifically designed for the sixth-generation Hyundai Sonata, this handle serves as a direct replacement for factory units that are cracked, broken, or failing to engage the door latch. This component is engineered for durability, ensuring a firm grip and smooth mechanical operation every time the door is opened.

This handle features a Smooth Black Finish intended for Paint-to-Match applications. This allows you to prime and paint the handle to coordinate perfectly with your vehicle's specific factory color code, providing a seamless, professional appearance that a standard textured plastic handle cannot offer.

Fitment Verification and Vehicle Applications

This exterior handle is designed for the Front Passenger Side on the following models:

• Hyundai Sonata: 2011, 2012, 2013, 2014.

Critical Fitment Note: This handle is designed for vehicles without Smart Key Keyless Entry. It does not feature the proximity sensor button or the internal wiring required for the push-button start system. This unit is intended for models with standard mechanical entry systems.

Technical Specifications and Attributes

• Position: Front Right (Passenger Side).

• Finish: Smooth Black (Ready for Paint).

• Paintable: Yes (Paint-to-Match).

• Material: Reinforced Impact-Resistant Plastic.

• Smart Key Compatibility: No (Standard Entry Only).

• Lock Cylinder Hole: No (Standard Passenger Side configuration).

• Grade Type: Standard Replacement.

What’s in the Box

• (1) Front Passenger Side Exterior Door Handle Assembly

Industry Cross-Reference Numbers

• Hyundai: 82651-3S000, 826513S000

• Secondary Reference: 82652-3S000, 826523S000

• Partslink: HY1311129

Installation and Technical Tips

• Paint Preparation: Before painting, clean the handle thoroughly with a wax and grease remover. Lightly scuff the smooth surface with a fine-grit abrasive pad and apply a plastic-adhesion promoter to ensure the paint bond withstands car washes and environmental exposure.

• Accessing the Latch: You can typically reach the mounting bolt through a small access hole located on the rear vertical edge of the door. Removing the plastic plug gives you a direct line to the 10mm bolt holding the handle cap in place.

• Avoid Dropping Hardware: Use a magnetized socket when loosening the retention bolt. If the bolt falls into the door cavity, you will be required to remove the entire interior door panel to retrieve it.

• Check the Gasket: Ensure the rubber gaskets behind the handle are aligned correctly against the door skin. A properly seated gasket prevents wind noise and keeps moisture from entering the door shell, protecting your door lock actuator.